Tel:0539-8631996
Mobile Phone:13869915758
Manager Zheng:18660933938
At present, many electroplating factories have deep moisture in the workplace due to the need to deal with a large amount of water during the production process; Due to the need to use a large amount of acidic liquids, there is also a lot of corrosive air, which causes the damage speed of electronic components to be relatively fast.
A more traditional solution is to pull the electrical part (control box) outdoors, which can cause a decrease in power and performance stability due to longer signal lines.
Advanced solution: Seal the electrical components without contact with moisture, leaving only the heat dissipation parts on the outside. This way, even if the corrosion of the casing is severe, electronic components will not have any problems, thus solving the problem of high failure rate.
